The Machining of Hard Mold Steel by Ultrasonic Assisted End Milling

Author： Tsai Ming Yi   Chang Chia Tai   Ho Jihng Kuo  

Publisher： MDPI

E-ISSN： 2076-3417|6|11|373-373

ISSN： 2076-3417

Source： Applied Sciences, Vol.6, Iss.11, 2016-11, pp. : 373-373

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Surface Roughness Analysis in the Hard Milling of JIS SKD61 Alloy Steel

By Nguyen Huu-That   Hsu Quang-Cherng  

Applied Sciences, Vol. 6, Iss. 6, 2016-06 ,pp. : 172-172

MDPI

Access to resources Recommend Favorite

Micro Machining of Injection Mold Inserts for Fluidic Channel of Polymeric Biochips

By Jung Woo-Chul   Heo Young-Moo   Yoon Gil-Sang   Shin Kwang-Ho   Chang Sung-Ho   Kim Gun-Hee   Cho Myeong-Woo  

Sensors, Vol. 7, Iss. 8, 2007-08 ,pp. : 1643-1654

MDPI

Access to resources Recommend Favorite

Response Ant Colony Optimization of End Milling Surface Roughness

By Kadirgama K.   Noor M. M.   Abd Alla Ahmed N.  

Sensors, Vol. 10, Iss. 3, 2010-03 ,pp. : 2054-2063

MDPI

Access to resources Recommend Favorite

Fabrication of Biochips with Micro Fluidic Channels by Micro End-milling and Powder Blasting

By Yun Dae Jin   Seo Tae Il   Park Dong Sam  

Sensors, Vol. 8, Iss. 2, 2008-02 ,pp. : 1308-1320

MDPI

Access to resources Recommend Favorite

Design and Implementation of an Electronic Front-End Based on Square Wave Excitation for Ultrasonic Torsional Guided Wave Viscosity Sensor

By Rabani Amir  

Sensors, Vol. 16, Iss. 10, 2016-10 ,pp. : 1681-1681

MDPI

Access to resources Recommend Favorite