Fabrication and Characterization of Al-0.4%Si-0.5%Mg - SiCp Using Permanent Mould Casting Technique

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2017|867|34-40

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2017, Iss.867, 2017-08, pp. : 34-40

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Characterization of Al-17wt.%Si Using Centrifugal Casting

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 399-404

Trans Tech Publications

Access to resources Recommend Favorite

Development and Characterization of Al-Si-Cu FGM Using Centrifuge Technique

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 438-442

Trans Tech Publications

Access to resources Recommend Favorite

The Fabrication of Co-Continuous SiC/P

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 727, 2015-03 ,pp. : 266-268

Trans Tech Publications

Access to resources Recommend Favorite

The Effect of Ceramic Reinforcement on the Microstructure, Mechanical Properties and Tribological Behavior of Al-7.5%Si-0.5%Mg Alloy

By  

Applied Mechanics and Materials, Vol. 2017, Iss. 867, 2017-08 ,pp. : 3-9

Trans Tech Publications

Access to resources Recommend Favorite

A multi-technique characterization of ZDDP antiwear films formed on Al (Si) alloy (A383) under various conditions

By Pereira G.   Lachenwitzer A.   Kasrai M.   Norton P.R.   Capehart T.W.   Perry T.A.   Cheng Y.-T.   Frazer B.   Gilbert P.U.P.A  

Tribology Letters, Vol. 26, Iss. 2, 2007-05 ,pp. : 103-117

Springer Publishing Company

Access to resources Recommend Favorite