Estimation of Anisotropy of Creep Properties in Al and Mg Alloys by Means of Small Punch Test

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2017|734|137-143

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.734, 2017-05, pp. : 137-143

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Determination of Creep Properties from Small Punch Test with Reverse Algorithm

By  

Key Engineering Materials, Vol. 2017, Iss. 734, 2017-05 ,pp. : 212-236

Trans Tech Publications

Access to resources Recommend Favorite

Determination of Mechanical Properties of Metallic Materials from Very Small Volumes by Means of Small Punch Test

By  

Key Engineering Materials, Vol. 2017, Iss. 741, 2017-07 ,pp. : 116-121

Trans Tech Publications

Access to resources Recommend Favorite

The High Temperature Creep Properties of a Thermally Sprayed CoNiCrAlY Coating via Small Punch Creep Testing

By  

Key Engineering Materials, Vol. 2017, Iss. 734, 2017-05 ,pp. : 37-48

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Strain Rate and Anisotropy on the Tensile Deformation Properties of Extruded AlZnMg Alloys

By Fjeldly Alexander   Roven Hans Jørgen  

Metallurgical and Materials Transactions A, Vol. 31, Iss. 3, 2000-03 ,pp. : 669-678

Springer Publishing Company

Access to resources Recommend Favorite

Creep resistant Mg-Al-Ca alloys: Computational thermodynamics and experimental investigation

By Ozturk Koray   Zhong Yu   Liu Zi-Kui   Luo Alan  

JOM, Vol. 55, Iss. 11, 2003-11 ,pp. : 40-44

Springer Publishing Company

Access to resources Recommend Favorite