Investigation on Hole Punching Process with Combined Punch to Improve Surface Quality during the Materials Forming Process

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2017|737|77-82

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.737, 2017-07, pp. : 77-82

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Improvement of Fatigue Strength of Hole Edge of Ultra-High Strength Steel Sheet by Punching Process Including Thickening

By  

Key Engineering Materials, Vol. 2016, Iss. 716, 2016-11 ,pp. : 428-434

Trans Tech Publications

Access to resources Recommend Favorite

Investigation on Variation of Bow Defect in Roll Forming Process

By  

Key Engineering Materials, Vol. 2017, Iss. 729, 2017-03 ,pp. : 80-85

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of Tensile and Compressive Creep Behaviour of AA2050-T34 during Creep Age Forming Process

By  

Key Engineering Materials, Vol. 2016, Iss. 716, 2016-11 ,pp. : 323-330

Trans Tech Publications

Access to resources Recommend Favorite

Finite element analysis and optimization of process parameters during stamp forming of composite materials

By  

IOP Conference Series: Materials Science and Engineering, Vol. 10, Iss. 1, 2010-06 ,pp. : 1338-1347

IOP Publishing

Access to resources Recommend Favorite

Combined TCT process for surface hardening of steels

By Aleksandrov V.  

Metal Science and Heat Treatment, Vol. 52, Iss. 5-6, 2010-11 ,pp. : 214-218

Springer Publishing Company

Access to resources Recommend Favorite