Evaluation of Mechanical Properties of Surface Layer Injection Molded Polypropylene by Nanoindentation Test

By  

Key Engineering Materials, Vol. 2016, Iss. 699, 2016-08 ,pp. : 86-90

Trans Tech Publications

Access to resources Recommend Favorite

Equipment for injection moulding of thermosetting materials based on ceramic and metal-ceramic powders

By Novikov N.   Ivzhenko V.   Popov V.   Leshchuk A.   Sarnavskaya G.  

Powder Metallurgy and Metal Ceramics, Vol. 43, Iss. 9, 2004-09 ,pp. : 538-545

Springer Publishing Company

Access to resources Recommend Favorite

Equipment for injection moulding of thermosetting materials based on ceramic and metal-ceramic powders

By Novikov N.   Ivzhenko V.   Popov V.   Leshchuk A.   Sarnavskaya G.  

Powder Metallurgy and Metal Ceramics, Vol. 43, Iss. 9-10, 2004-09 ,pp. : 538-545

Springer Publishing Company

Access to resources Recommend Favorite

Influence of Process Conditions on the Local Shrinkage and on the Pressure Evolution inside the Mold Cavity of the Injection Molded Polypropylene in Two Modifications - PP Homopolymer; 40 % Talc Filled PP

By  

Key Engineering Materials, Vol. 2015, Iss. 669, 2016-02 ,pp. : 11-18

Trans Tech Publications

Access to resources Recommend Favorite

Mould wall friction effects on micro injection moulding based on simulation of MIS

By  

IOP Conference Series: Materials Science and Engineering, Vol. 10, Iss. 1, 2010-06 ,pp. : 1368-1377

IOP Publishing

Access to resources Recommend Favorite