Tool Life Analysis when Turning Ti-6Al-4V Using Vegetable Oil-Based Cutting Fluid

E-ISSN： 1662-9752|2017|882|36-40

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.882, 2017-02, pp. : 36-40

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Friction Modeling and Experimental Research of Tool-Chip in Turning Titanium Alloy Ti6Al4V

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 126-131

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Cutting Parameters and Tool Geometry on Thrust Force Behavior in Drilling Ti6Al4V

Materials Science Forum, Vol. 2016, Iss. 862, 2016-09 ,pp. : 3-10

Trans Tech Publications

Access to resources Recommend Favorite

Diffusion bonding of TiAl based alloy to Ti–6Al–4V alloy using amorphous interlayer

MATERIALWISSENSCHAFT UND WERKSTOFFTECHNIK, Vol. 46, Iss. 1, 2015-01 ,pp. : 40-46

John Wiley & Sons Inc

Access to resources Recommend Favorite

Experimental Investigation of Mechanical-Thermal Characteristics in High Efficiency Turning Titanium Alloy Ti6Al4V

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 20-28

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Cutting Atmosphere on High-Speed End Milling Process for Titanium Alloy Ti6Al4V

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 46-51

Trans Tech Publications

Access to resources Recommend Favorite