Influence of the Direct Metal Laser Sintering Process on the Fatigue Behavior of the Ti6Al4V Alloy

E-ISSN： 1662-9752|2017|891|317-321

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.891, 2017-04, pp. : 317-321

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Metallographic Characterization and Fatigue Damage Initiation in Ti6Al4V Alloy Produced by Direct Metal Laser Sintering

Materials Science Forum, Vol. 2017, Iss. 891, 2017-04 ,pp. : 311-316

Trans Tech Publications

Access to resources Recommend Favorite

Behavior of alloy Ti-6Al-4V under pre-fretting and subsequent fatigue conditions

By Glaeser W.A. Lawless B.H.

Wear, Vol. 250, Iss. 1, 2001-10 ,pp. : 621-630

Elsevier

Access to resources Recommend Favorite

Influence of artificial and casting defects on fatigue strength of moulded components in Ti‐6Al‐4V alloy

FATIGUE & FRACTURE OF ENGINEERING MATERIALS AND STRUCTURES, Vol. 38, Iss. 9, 2015-09 ,pp. : 1026-1041

John Wiley & Sons Inc

Access to resources Recommend Favorite

Influence of microstructure on fatigue crack propagation under bending in the alloy Ti–6Al–4V after heat treatment

MATERIALWISSENSCHAFT UND WERKSTOFFTECHNIK, Vol. 46, Iss. 11, 2015-11 ,pp. : 1088-1095

John Wiley & Sons Inc

Access to resources Recommend Favorite

Laser melting of plasma nitrided Ti-6Al-4V alloy

By Yilbas B.S. Sami M. Shuja S.Z. Aleem A. Nickel J. Coban A.

Wear, Vol. 212, Iss. 1, 1997-11 ,pp. : 140-149

Elsevier

Access to resources Recommend Favorite