Influence of Precipitation Hardening on the Sliding Wear Behavior of a Cu-Zn-Al-Mn-Si Based Brass Alloy

E-ISSN： 1662-9752|2017|898|355-360

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.898, 2017-07, pp. : 355-360

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The sliding wear resistance behavior of NiAl and SiC particles reinforced aluminum alloy matrix composites

By Chen R. Iwabuchi A. Shimizu T. Mifune H. Shin H.S.

Wear, Vol. 213, Iss. 1, 1997-12 ,pp. : 175-184

Elsevier

Access to resources Recommend Favorite

Microstructure and dry sliding wear behavior of laser clad Ni-based alloy coating with the addition of SiC

By Li Q. Song G.M. Zhang Y.Z. Lei T.C. Chen W.Z.

Wear, Vol. 254, Iss. 3, 2003-02 ,pp. : 222-229

Elsevier

Access to resources Recommend Favorite

Dry Sliding Wear Behavior of Ti-6Al-4V Alloy

Materials Science Forum, Vol. 2015, Iss. 830, 2015-10 ,pp. : 333-336

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Hot Extrusion on Microstructure and Hardness of SiC Particle Reinforced Al-Zn-Mg-Cu Alloy Matrix Composite

Materials Science Forum, Vol. 2015, Iss. 816, 2015-05 ,pp. : 118-125

Trans Tech Publications

Access to resources Recommend Favorite

Study of Microstructure and Wear Behavior of T6 Heat Treated as Cast Al-25Mg₂Si-2Cu Alloy

Materials Science Forum, Vol. 2015, Iss. 830, 2015-10 ,pp. : 358-361

Trans Tech Publications

Access to resources Recommend Favorite