Fabrication and Properties of In Situ B₁₃P₂ Reinforced Cu-Based Composites

E-ISSN： 1662-9752|2017|898|1007-1014

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.898, 2017-07, pp. : 1007-1014

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Fabrication of Al-Based Composites Cylinder Reinforced with In Situ Si/Mg₂Si Particles and the Research of its Bench Test

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 116-121

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and Mechanical Properties of TiC/Ti₃AlC₂ In Situ Composites Prepared by Hot Pressing Method

Materials Science Forum, Vol. 2015, Iss. 816, 2015-05 ,pp. : 200-204

Trans Tech Publications

Access to resources Recommend Favorite

Effect of TiB₂ Content on Microstructure and Hardness of In Situ TiB₂ Reinforced High Zinc Content Al-Zn-Mg-Cu-Zr Composite Materials

Materials Science Forum, Vol. 2017, Iss. 894, 2017-05 ,pp. : 34-37

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure on Laser In Situ Deposit of TiB_x/TiC ReinforcedComposite Coatings

Materials Science Forum, Vol. 2016, Iss. 849, 2016-04 ,pp. : 665-670

Trans Tech Publications

Access to resources Recommend Favorite

Properties of Ni_0.5Zn_0.5Fe₂O₄/Fe₇₆Si₉B₁₀P₅ Bulk Soft Magnetic Composites by Annealing Treatment

Materials Science Forum, Vol. 2017, Iss. 898, 2017-07 ,pp. : 684-688

Trans Tech Publications

Access to resources Recommend Favorite