The Investigation of Electrochemical Slurry Jet Micro Machining on the SKD11 Mold Steel

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2017|749|148-153

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.749, 2017-09, pp. : 148-153

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Numerical investigation of the interface in a continuous steel casting mold water model

By Theodorakakos A.   Bergeles G.  

Metallurgical and Materials Transactions B, Vol. 29, Iss. 6, 1998-12 ,pp. : 1321-1327

Springer Publishing Company

Access to resources Recommend Favorite

Numerical investigation of the free surface in a continuous steel casting mold model

By Panaras G.   Theodorakakos A.   Berggeles G.  

Metallurgical and Materials Transactions B, Vol. 29, Iss. 5, 1998-10 ,pp. : 1117-1126

Springer Publishing Company

Access to resources Recommend Favorite

A comparative study on the surface integrity of plastic mold steel due to electric discharge machining

By Ekmekci Bülent   Elkoca Oktay   Erden Abdulkadir  

Metallurgical and Materials Transactions B, Vol. 36, Iss. 1, 2005-02 ,pp. : 117-124

Springer Publishing Company

Access to resources Recommend Favorite

Microstructural characterization of WC-TiC-Co cutting tools during high-speed machining of P20 mold steel

By Farhat Z.N.  

Materials Characterization, Vol. 51, Iss. 2, 2003-10 ,pp. : 117-130

Elsevier

Access to resources Recommend Favorite

Water model study of horizontal molten steel-Ar two-phase jet in a continuous casting mold

By Iguchi Manabu   Kasai Norifumi  

Metallurgical and Materials Transactions B, Vol. 31, Iss. 3, 2000-06 ,pp. : 453-460

Springer Publishing Company

Access to resources Recommend Favorite