Publisher： Trans Tech Publications
E-ISSN： 1662-9795|2017|749|15-20
ISSN： 1013-9826
Source： Key Engineering Materials, Vol.2017, Iss.749, 2017-09, pp. : 15-20
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
Influence of the Cutting Fluid on Tool Edge Temperature in End Milling of Titanium Alloy
Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. :
Access to resources
Recommend
Evaluation of Relationship between Cutting Parameters and Torque in Hole Making of Titanium Alloy
Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. :
Air Jet Assisted End Milling of Titanium Alloy Ti-6Al-4V ELI at High Cutting Speed
Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. :
Strength of Cutting Tool in Titanium Alloy Machining
Key Engineering Materials, Vol. 2016, Iss. 685, 2016-03 ,pp. :
Temperature Modeling Analysis for Milling of Titanium Alloy
Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. :