Formability Analysis of Fukui Stretch-Drawing and Square Cup Drawing Using Strain and Stress Based Forming Limit Curves

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2017|751|167-172

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.751, 2017-09, pp. : 167-172

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Multi-Stage Cold Deep Drawing of Pure Titanium Square Cup

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1072-1077

Trans Tech Publications

Access to resources Recommend Favorite

Curvature Based Forming Limit Prediction of High-Strength Steel Components with Superimposed Stretching and Bending in the Deep Drawing Process

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 181-186

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Single and Summary Deformation for the Change of Limit Stress in the Drawing Process Based on the Pelczynski Diagram

By  

Solid State Phenomena, Vol. 2016, Iss. 246, 2016-03 ,pp. : 183-188

Trans Tech Publications

Access to resources Recommend Favorite

Formability Discussion in Dieless Drawing of Stainless Steel Tubes

By  

Key Engineering Materials, Vol. 2014, Iss. 626, 2015-01 ,pp. : 10-15

Trans Tech Publications

Access to resources Recommend Favorite

Estimating surface hardening profile of blank for obtaining high drawing ratio in deep drawing process using FE analysis

By  

IOP Conference Series: Materials Science and Engineering, Vol. 103, Iss. 1, 2015-12 ,pp. : 338-343

IOP Publishing

Access to resources Recommend Favorite