![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Publisher: Trans Tech Publications
E-ISSN: 1662-9779|2017|261|251-258
ISSN: 1012-0394
Source: Solid State Phenomena, Vol.2017, Iss.261, 2017-09, pp. : 251-258
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Surface Roughness Prediction in Face Milling by Special Tools
Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Comparison of Theoretical and Real Surface Roughness in Case of Ball-End Milling
Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Influence of Micro End Mill Tool Run-Out on Machining Accuracy
Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. :