Bending Fatigue Analysis of PM Gears

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2017|754|299-302

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.754, 2017-10, pp. : 299-302

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Modeling the Effect of Carburization and Quenching on the Development of Residual Stresses and Bending Fatigue Resistance of Steel Gears

By Li Zhichao  

Journal of Materials Engineering and Performance, Vol. 22, Iss. 3, 2013-03 ,pp. : 664-672

Springer Publishing Company

Access to resources Recommend Favorite

Improvement of fatigue properties of PM steels by shot peening

By Saritas S.   Dogan C.   Varol R.  

Powder Metallurgy, Vol. 42, Iss. 2, 1999-02 ,pp. : 126-130

Maney Publishing

Access to resources Recommend Favorite

Fatigue of Inhomogeneous Low Alloy PM Steels

By Douib N.   Mellanby I. J.   Moon J. R.  

Powder Metallurgy, Vol. 32, Iss. 3, 1989-01 ,pp. : 209-214

Maney Publishing

Access to resources Recommend Favorite

Fatigue crack propagation in some PM steels

By Phillips R.A.   King J.E.   Moon J.R.  

Powder Metallurgy, Vol. 43, Iss. 2, 2000-02 ,pp. : 149-156

Maney Publishing

Access to resources Recommend Favorite

The Influence of the Specimen Shape on the Fatigue Life under Bending

By  

Solid State Phenomena, Vol. 2016, Iss. 251, 2016-08 ,pp. : 35-40

Trans Tech Publications

Access to resources Recommend Favorite