Effect of Tool Path Parameters on Part Porosity in Fused Filament Fabrication of Poly(Ethylene-co-Trimethylene Terephthalate)

Publisher： Trans Tech Publications

E-ISSN： 1662-9507|2018|382|99-103

ISSN： 1012-0386

Source： Defect and Diffusion Forum, Vol.2018, Iss.382, 2018-02, pp. : 99-103

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Extrusion Temperature and Flow Rate Effects on Tensile Properties of Additively Processed Poly(Ethylene-co-Trimethylene Terephthalate)

By  

Defect and Diffusion Forum, Vol. 2018, Iss. 382, 2018-02 ,pp. : 104-108

Trans Tech Publications

Access to resources Recommend Favorite

Modeling of porosity during spray forming: Part I. Effects of processing parameters

By Cai Weidong   Lavernia Enrique  

Metallurgical and Materials Transactions B, Vol. 29, Iss. 5, 1998-10 ,pp. : 1085-1096

Springer Publishing Company

Access to resources Recommend Favorite

Effect of Graphene Oxide on Non-Isothermal Melt Crystallization Kinetics of Poly(Trimethylene Terephthalate)

By  

Key Engineering Materials, Vol. 2017, Iss. 748, 2017-09 ,pp. : 74-78

Trans Tech Publications

Access to resources Recommend Favorite

Characterization of poly(ethylene terephthalate) used in commercial bottled water

By  

IOP Conference Series: Materials Science and Engineering, Vol. 5, Iss. 1, 2009-09 ,pp. : 34-38

IOP Publishing

Access to resources Recommend Favorite

The preparation of flame-retardant poly (ethylene terephthalate) fabric by ionic agent

By  

IOP Conference Series: Materials Science and Engineering, Vol. 87, Iss. 1, 2015-07 ,pp. : 683-687

IOP Publishing

Access to resources Recommend Favorite