Combining 3D Scanning with Standard Microscopy Methods for Assessment of Pitting Corrosion in Turbine Blades

E-ISSN： 1662-9779|2017|270|168-173

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2017, Iss.270, 2017-12, pp. : 168-173

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effects of Atmospheric Conditions on Slag Corrosion Resistance of Lightweight Al₂O₃-MgO Castables

Key Engineering Materials, Vol. 2018, Iss. 768, 2018-06 ,pp. : 274-278

Trans Tech Publications

Access to resources Recommend Favorite

Corrosion of Fe₃Al-4Cr Alloys at 1000°C in N₂-0.1%H₂S Gas

Key Engineering Materials, Vol. 2018, Iss. 765, 2018-05 ,pp. : 173-177

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of Corrosion Attack on Kaplan Turbine Blades

Solid State Phenomena, Vol. 2017, Iss. 270, 2017-12 ,pp. : 149-155

Trans Tech Publications

Access to resources Recommend Favorite

The Impact of Detection Methods on the Results of Quantitative Analysis of the Surface Layer WC-CoAl₂O₃

Solid State Phenomena, Vol. 2015, Iss. 235, 2015-08 ,pp. : 45-51

Trans Tech Publications

Access to resources Recommend Favorite

Preparation and Characterization of Al-Al₂O₃ Metal Ceramics via Powder Metallurgy Methods

Key Engineering Materials, Vol. 2016, Iss. 697, 2016-08 ,pp. : 350-353

Trans Tech Publications

Access to resources Recommend Favorite