Heat Transfer and Phase Formation through EBM 3D-Printing of Ti-6Al-4V Cylindrical Parts

Publisher： Trans Tech Publications

E-ISSN： 1662-9507|2018|383|190-195

ISSN： 1012-0386

Source： Defect and Diffusion Forum, Vol.2018, Iss.383, 2018-03, pp. : 190-195

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Optimizing HIP and Printing Parameters for EBM Ti-6Al-4V

By  

Key Engineering Materials, Vol. 2018, Iss. 770, 2018-07 ,pp. : 174-178

Trans Tech Publications

Access to resources Recommend Favorite

Machinability of the EBM Ti6Al4V in Cryogenic Turning

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1183-1188

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of Heat Transfer through PVC Window Profile Reinforced with Ti6Al4V Alloy

By  

Key Engineering Materials, Vol. 2016, Iss. 687, 2016-05 ,pp. : 236-242

Trans Tech Publications

Access to resources Recommend Favorite

Determination of interface heat-transfer coefficients for permanent-mold casting of Ti-6Al-4V

By Kobryn P.   Semiatin S.  

Metallurgical and Materials Transactions B, Vol. 32, Iss. 4, 2001-08 ,pp. : 685-695

Springer Publishing Company

Access to resources Recommend Favorite

Infrared heat treatment of Ti-6Al-4V with electroplated Cu

By Li J.   Deshpande P.   Lin R.  

Journal of Materials Engineering and Performance, Vol. 13, Iss. 4, 2004-08 ,pp. : 445-450

Springer Publishing Company

Access to resources Recommend Favorite