Author: Yamamoto Kenji Abdoos Majid Paiva Jose Mario Stolf Pietro Beake Ben Rawal Sushant Fox-Rabinovich German Veldhuis Stephen
Publisher: MDPI
E-ISSN: 2079-6412|8|1|38-38
ISSN: 2079-6412
Source: Coatings, Vol.8, Iss.1, 2018-01, pp. : 38-38
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
A new family of physical vapor deposited (PVD) coatings is presented in this paper. These coatings are deposited by a superfine cathode (SFC) using the arc method. They combine a smooth surface, high hardness, and low residual stresses. This allows the production of PVD coatings as thick as 15 µm. In some applications, in particular for machining of such hard to cut material as compacted graphite iron (CGI), such coatings have shown better tool life compared to the conventional PVD coatings that have a lower thickness in the range of up to 5 μm. Finite element modeling of the temperature/stress profiles was done for the SFC coatings to present the temperature/stress profiles during cutting. Comprehensive characterization of the coatings was performed using XRD, TEM, SEM/EDS studies, nano-hardness, nano-impact measurements, and residual stress measurements. Application of the coating with this set of characteristics reduces the intensity of buildup edge formation during turning of CGI, leading to longer tool life. Optimization of the TiAlN-based coatings composition (Ti/Al ratio), architecture (mono vs. multilayer), and thickness were performed. Application of the optimized coating resulted in a 40–60% improvement in the cutting tool life under finishing turning of CGI.
Related content
By Cadena Natalia L. Cue-Sampedro Rodrigo Siller Héctor R. Arizmendi-Morquecho Ana M. Rivera-Solorio Carlos I. Di-Nardo Santiago
Materials, Vol. 6, Iss. 6, 2013-05 ,pp. :
Effect of Hexagonal Phase Content on Wear Behaviour of AlTiN Arc PVD Coatings
By Kohlscheen Joern Bareiss Christian
Coatings, Vol. 8, Iss. 2, 2018-02 ,pp. :
Phase Stability and Elasticity of TiAlN
By Abrikosov Igor A. Knutsson Axel Alling Björn Tasnádi Ferenc Lind Hans Hultman Lars Odén Magnus
Materials, Vol. 4, Iss. 9, 2011-09 ,pp. :
By Subramanian B. Umamaheswari G. Jayachandran M.
Corrosion Engineering, Science and Technology, Vol. 42, Iss. 4, 2007-12 ,pp. :