On the Effect of the Cutting Speed of a Water Jet Abrasive Cutting Process on the Surface Morphology of the Low Carbon Steel S235

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2018|919|92-100

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2018, Iss.919, 2018-05, pp. : 92-100

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Effect of Cutting Speed and Feed Rate on Surface Roughness and Tool Wear when Machining Machining D2 Steel

By  

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 80-85

Trans Tech Publications

Access to resources Recommend Favorite

Influence of the critical cutting speed on the surface finish of turned steel

By Munoz-Escalona P.   Cassier Z.  

Wear, Vol. 218, Iss. 1, 1998-06 ,pp. : 103-109

Elsevier

Access to resources Recommend Favorite

Wear rates and wear mechanisms of alumina-based tools cutting steel at a low cutting speed

By Lo Casto S.   Lo Valvo E.   Lucchini E.   Maschio S.   Ruisi V.F.  

Wear, Vol. 208, Iss. 1, 1997-07 ,pp. : 67-72

Elsevier

Access to resources Recommend Favorite

The Cutting Speed Influences on Tool Wear of ZTA Ceramic Cutting Tools and Surface Roughness of Work Material Stainless Steel 316L during High Speed Machining

By  

Materials Science Forum, Vol. 2016, Iss. 840, 2016-02 ,pp. : 315-320

Trans Tech Publications

Access to resources Recommend Favorite

Cutting carbon

By  

CHEMISTRY & INDUSTRY, Vol. 9-3068, Iss. 9, 2015-09 ,pp. : 40-40

John Wiley & Sons Inc

Access to resources Recommend Favorite