Drawing Force Optimization Research on Forming Parameters of Drawing Wire Rod with Rotating Die under Coulomb Friction

E-ISSN： 1662-9752|2018|920|3-9

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2018, Iss.920, 2018-05, pp. : 3-9

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Identification of Coulomb's friction coefficient in real contact conditions applied to a wire drawing process

By Dubar L. Dubois A. Oudin J. Lazzarotto L. Ravassard P.

Wear, Vol. 211, Iss. 1, 1997-10 ,pp. : 54-63

Elsevier

Access to resources Recommend Favorite

Study by Numerical Simulation of the Deep Drawing Parameters-Material during the Wheelbarrow Forming

Materials Science Forum, Vol. 2017, Iss. 895, 2017-05 ,pp. : 94-98

Trans Tech Publications

Access to resources Recommend Favorite

Frictional characteristics of fatty-based oils in wire drawing

By Obi A.I. Oyinlola A.K.

Wear, Vol. 194, Iss. 1, 1996-06 ,pp. : 30-37

Elsevier

Access to resources Recommend Favorite

Research on Process of Drawing Flexible Glass

Materials Science Forum, Vol. 2014, Iss. 809, 2015-02 ,pp. : 278-282

Trans Tech Publications

Access to resources Recommend Favorite

The influence of die geometry on tool wear in deep drawing

By Eriksen M.

Wear, Vol. 207, Iss. 1, 1997-06 ,pp. : 10-15

Elsevier

Access to resources Recommend Favorite