Optimizing Design of the Cutting Tool in Cutting of Ultra-High Strength Steel Beam Part

E-ISSN： 1662-9752|2018|920|120-125

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2018, Iss.920, 2018-05, pp. : 120-125

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Principle and Model of Phase Transformation in Ultra-High Strength Steel for Cone Crusher

Materials Science Forum, Vol. 2016, Iss. 850, 2016-04 ,pp. : 636-641

Trans Tech Publications

Access to resources Recommend Favorite

Cutting Temperature and Cutting Forces Investigation Based on the Taguchi Design Method when High-Speed Milling of Titanium Matrix Composites with PCD Tool

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 168-174

Trans Tech Publications

Access to resources Recommend Favorite

The Modelling of Crater Wear in Cutting with TiN Coated High Speed Steel Tool

Materials Science Forum, Vol. 2015, Iss. 812, 2015-03 ,pp. : 227-232

Trans Tech Publications

Access to resources Recommend Favorite

The Cutting Speed Influences on Tool Wear of ZTA Ceramic Cutting Tools and Surface Roughness of Work Material Stainless Steel 316L during High Speed Machining

Materials Science Forum, Vol. 2016, Iss. 840, 2016-02 ,pp. : 315-320

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of the cutting tool on a lathe

By Nayfeh Ali Nayfeh Nader

Nonlinear Dynamics, Vol. 63, Iss. 3, 2011-02 ,pp. : 395-416

Springer Publishing Company

Access to resources Recommend Favorite