Quantitative Evolution of WC-Co Cemented Carbide Tool Surface during the Cold Forming of Steel Parts

E-ISSN： 1662-9795|2018|767|290-297

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2018, Iss.767, 2018-06, pp. : 290-297

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Some speculations on an increase of WC-Co cemented carbide service life under dynamic loads

By Lisovsky A.F.

International Journal of Refractory and Hard Metals, Vol. 21, Iss. 1, 2003-01 ,pp. : 63-67

Elsevier

Access to resources Recommend Favorite

Powder injection molding of WC-8%Co tungsten cemented carbide

By Baojun Z. Xuanhui Q. Ying T.

International Journal of Refractory and Hard Metals, Vol. 20, Iss. 5, 2002-12 ,pp. : 389-394

Elsevier

Access to resources Recommend Favorite

Influence of Porosity on Strength of WC–10%Co Cemented Carbide

By Nordgren A. Melander A.

Powder Metallurgy, Vol. 31, Iss. 3, 1988-01 ,pp. : 189-200

Maney Publishing

Access to resources Recommend Favorite

Use of modern tool steel and surface engineering in sheet cold forming

By Hansson P Liljengren M

International Heat Treatment & Surface Engineering, Vol. 7, Iss. 3, 2013-09 ,pp. : 140-143

Maney Publishing

Access to resources Recommend Favorite

On the contiguity of carbide phase in WC-Co hardmetals

By Golovchan V.T. Litoshenko N.V.

International Journal of Refractory and Hard Metals, Vol. 21, Iss. 5, 2003-09 ,pp. : 241-244

Elsevier

Access to resources Recommend Favorite