A Study on DLC Tool Coating for Deep Drawing and Ironing of Stainless Steel

E-ISSN： 1662-9795|2018|767|181-188

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2018, Iss.767, 2018-06, pp. : 181-188

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Study the effect of elevated dies temperature on aluminium and steel round deep drawing

IOP Conference Series: Materials Science and Engineering, Vol. 114, Iss. 1, 2016-02 ,pp. : 89-102

IOP Publishing

Access to resources Recommend Favorite

Formability Discussion in Dieless Drawing of Stainless Steel Tubes

Key Engineering Materials, Vol. 2014, Iss. 626, 2015-01 ,pp. : 10-15

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Study on Surface Element Composition and Hydrophobic Properties of DLC Coating

Key Engineering Materials, Vol. 2018, Iss. 764, 2018-03 ,pp. : 58-67

Trans Tech Publications

Access to resources Recommend Favorite

A Study on Tool Damage of Threading Tap in Screw Cutting of Stainless Steel 15-5PH

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 164-167

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of annealing parameters for improvement in formability of extra deep drawing quality steel

By Sarkar Biswajit Jha B. Deva Anjana

Journal of Materials Engineering and Performance, Vol. 13, Iss. 3, 2004-06 ,pp. : 361-365

Springer Publishing Company

Access to resources Recommend Favorite