Initial Tool Orientation Set-up for 5-Axis Flank Milling Based on Faceted Models

E-ISSN： 2261-236x|108|issue|04006-04006

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.108, Iss.issue, 2017-05, pp. : 04006-04006

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Non Machinable Volume Calculation Method for 5-Axis Roughing Based on Faceted Models through Closed Bounded Area Evaluation

MATEC Web of conference, Vol. 108, Iss. issue, 2017-05 ,pp. : 04015-04015

Edp Sciences

Access to resources Recommend Favorite

Tool Wear Analysis on Five-Axis Flank Milling for Curved Shape Part – Full Flute and Ground Shank End Mill

MATEC Web of conference, Vol. 97, Iss. issue, 2017-02 ,pp. : 01091-01091

Edp Sciences

Access to resources Recommend Favorite

The tool profile and the localization of the revolution axis for irregular outline milling

MATEC Web of conference, Vol. 94, Iss. issue, 2017-01 ,pp. : 05005-05005

Edp Sciences

Access to resources Recommend Favorite

Laboratory test set-up for the evaluation of rainfall-noise

By Vermeir G. Mees P.

INTER-NOISE and NOISE-CON Congress and Conference Proceedings, Vol. 2000, Iss. 9, 2000-08 ,pp. : 382-391

Institute of Noise Control Engineering

Access to resources Recommend Favorite

A set-up for flexible geometry optical lattices

By Saers R. Rehn M. Scheler T. Zelán M. Kastberg A.

EPJ Applied Physics (The), Vol. 42, Iss. 3, 2008-06 ,pp. : 269-273

Edp Sciences

Access to resources Recommend Favorite