Publisher： Edp Sciences
E-ISSN： 2261-236x|121|issue|06007-06007
ISSN： 2261-236x
Source： MATEC Web of conference, Vol.121, Iss.issue, 2017-08, pp. : 06007-06007
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
In this paper, we propose an electrical design (implemented on a PCB board) and an accompanying software design for controlling the automatic gear change. The designs complement the mechanical solutions developed in Part 1. The paper also analyses the issues encountered during the intermediate steps of the development of the electronic module, which is expected to be small and adaptable enough to be installed on a motorcycle without changing its ergonomics. The control software runs on the Arduino Nano board and is built as a state machine with one idle state, five active states that cover different stages of the gear change and one error state for preventing malfunctions in case of an unexpected event. The sketch uses 5,760 bytes (or 18%) of program storage space and 706 bytes (or 34%) of the dynamic memory.
Related content
Access to resources
Recommend
Access to resources