The relationship of cutting force with hole quality in drilling process of AISI H13 steel

Publisher： Edp Sciences

E-ISSN： 2261-236x|129|issue|01042-01042

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.129, Iss.issue, 2017-11, pp. : 01042-01042

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Investigation on hole quality of cutting conditions in drilling of CFRP composite

By  

MATEC Web of conference, Vol. 112, Iss. issue, 2017-07 ,pp. : 01013-01013

Edp Sciences

Access to resources Recommend Favorite

Experimental and analytical analyses of the cutting process in the deep hole drilling with BTA (Boring Trepanning Association) system

By Thil J.   Haddag B.   Nouari M.   Barlier C.   Papillon L.  

Mechanics & Industry, Vol. 14, Iss. 6, 2014-02 ,pp. : 413-429

Edp Sciences

Access to resources Recommend Favorite

Comparison between mixed ceramic and reinforced ceramic tools in terms of cutting force components modelling and optimization when machining hardened steel AISI 4140 (60 HRC)

By Fnides B.   Aouici H.   Elbah M.   Boutabba S.   Boulanouar L.  

Mechanics & Industry, Vol. 16, Iss. 6, 2015-09 ,pp. : 609-609

Edp Sciences

Access to resources Recommend Favorite

Tool material, tool wear and machined hole quality evaluation at CFRP drilling

By  

MATEC Web of conference, Vol. 112, Iss. issue, 2017-07 ,pp. : 01015-01015

Edp Sciences

Access to resources Recommend Favorite

Prediction of surface roughness and cutting force under MQL turning of AISI 4340 with nano fluid by using response surface methodology

By Patole Pralhad B.   Kulkarni Vivek V.  

Manufacturing Review, Vol. 5, Iss. issue, 2018-06 ,pp. : 5-5

Edp Sciences

Access to resources Recommend Favorite