The fractography analysis of IN718 alloy after three-point flexure fatigue test

E-ISSN： 2261-236x|157|issue|07001-07001

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.157, Iss.issue, 2018-03, pp. : 07001-07001

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental and numerical investigation of mode II failure behavior evaluation using three point bend, end notched flexure test

MATEC Web of conference, Vol. 144, Iss. issue, 2018-01 ,pp. : 02009-02009

Edp Sciences

Access to resources Recommend Favorite

Effect of microstructure refinement on low cycle fatigue behavior of Alloy 718

MATEC Web of conference, Vol. 14, Iss. issue, 2014-08 ,pp. : 04001-04001

Edp Sciences

Access to resources Recommend Favorite

Processing dynamic split Hopkinson three-point bending test with normalized specimen of quasi-brittle material

By Hanus Jean-Luc Magnain Benoît Durand Bastien Alanis-Rodriguez Javier Bailly Patrice

Mechanics & Industry, Vol. 13, Iss. 6, 2013-04 ,pp. : 381-393

Edp Sciences

Access to resources Recommend Favorite

Evaluation of notch effects in low cycle fatigue of alloy 718 using critical distances

By Eriksson Robert

MATEC Web of conference, Vol. 165, Iss. issue, 2018-05 ,pp. : 15001-15001

Edp Sciences

Access to resources Recommend Favorite

Influence of surface residual stresses on the fatigue life and crack propagation behavior of turned Inconel 718 super-alloy

By Javadi Hamid

MATEC Web of conference, Vol. 165, Iss. issue, 2018-05 ,pp. : 18004-18004

Edp Sciences

Access to resources Recommend Favorite