FE modeling of a complete warm-bending process for optimal design of heating stages for the forming of large-diameter thin-walled Ti–6Al–4V tubes

Author： Tao Zhijun   Li Heng   Ma Jun   Yang Heng   Lei Chao   Li Guangjun  

Publisher： Edp Sciences

E-ISSN： 2265-4224|4|issue|8-8

ISSN： 2265-4224

Source： Manufacturing Review, Vol.4, Iss.issue, 2017-08, pp. : 8-8

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Analysis of shearing deformation in rolling-spinning forming of Ti-6Al-2Zr-1Mo-1V tubes

By  

MATEC Web of conference, Vol. 21, Iss. issue, 2015-08 ,pp. : 03008-03008

Edp Sciences

Access to resources Recommend Favorite

Density of liquid Ti-6Al-4V

By  

EPJ Web of Conference, Vol. 151, Iss. issue, 2017-08 ,pp. : 04003-04003

Edp Sciences

Access to resources Recommend Favorite

Pre-fatigue influence on quasi-static tensile properties of Ti-6Al-4V in thin-sheet form

By Gálan Lópeza J.  

EPJ Web of Conference, Vol. 6, Iss. issue, 2010-06 ,pp. : 42022-42022

Edp Sciences

Access to resources Recommend Favorite

Free vibrations of thin-walled semi-underground main gas pipelines of large diameter, with the attached ground mass

By Sokolov Vladimir  

MATEC Web of conference, Vol. 106, Iss. issue, 2017-05 ,pp. : 02021-02021

Edp Sciences

Access to resources Recommend Favorite

Modeling incision profile in AWJM of Titanium alloys Ti6Al4V

By Sultan Tarek   Gilles Patrick   Cohen Guillaume   Cenac François   Rubio Walter  

Mechanics & Industry, Vol. 17, Iss. 4, 2016-03 ,pp. : 403-403

Edp Sciences

Access to resources Recommend Favorite