Additive Manufacturing of Ti-6Al-4V with Added Boron: Microstructure and Hardness Modification

E-ISSN： 1662-9795|2018|770|165-173

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2018, Iss.770, 2018-07, pp. : 165-173

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Surface modification of additive manufactured Ti6Al4V alloy with Ag nanoparticles: wettability and surface morphology study

IOP Conference Series: Materials Science and Engineering, Vol. 116, Iss. 1, 2016-02 ,pp. : 19-24

IOP Publishing

Access to resources Recommend Favorite

Investigation of the HA film deposited on the porous Ti6Al4V alloy prepared via additive manufacturing

IOP Conference Series: Materials Science and Engineering, Vol. 98, Iss. 1, 2015-11 ,pp. : 170-174

IOP Publishing

Access to resources Recommend Favorite

Characterization of Gas Atomized Ti-6Al-4V Powders for Additive Manufacturing

Key Engineering Materials, Vol. 2018, Iss. 770, 2018-07 ,pp. : 3-8

Trans Tech Publications

Access to resources Recommend Favorite

Manufacturing Ti-6Al-4V Components by Shaped Metal Deposition: Microstructure and Mechanical Properties

IOP Conference Series: Materials Science and Engineering, Vol. 26, Iss. 1, 2011-12 ,pp. : 3-10

IOP Publishing

Access to resources Recommend Favorite

The laser additive manufacture of Ti-6Al-4V

By Kobryn P. Semiatin S.

JOM, Vol. 53, Iss. 9, 2001-09 ,pp. : 40-42

Springer Publishing Company

Access to resources Recommend Favorite