Numerical Approach at Flat Plate for Predicting the Film Cooling Effectiveness Part B: Effect Injection Angle

E-ISSN： 2296-3642|2018|16|57-71

ISSN： 2296-3650

Source： Diffusion Foundations, Vol.2018, Iss.16, 2018-07, pp. : 57-71

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Numerical Approach at Flat Plate for Predicting the Film Cooling Effectiveness Part A: Effect Blowing Ratio

Diffusion Foundations, Vol. 2018, Iss. 16, 2018-07 ,pp. : 30-44

Trans Tech Publications

Access to resources Recommend Favorite

The Effect of Lattice Orientation on the Film Hole Deformation of Nickel-Based Single Crystal Plate Specimen

Materials Science Forum, Vol. 2018, Iss. 932, 2018-10 ,pp. : 39-43

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Magnetic Field on the Fiber Orientation during the Filling Process in Injection Molding, Part 2: Experiments and Electrical Conductivity Measurements

Materials Science Forum, Vol. 2018, Iss. 936, 2018-11 ,pp. : 136-141

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Magnetic Field on the Fiber Orientation during the Filling Process in Injection Molding, Part 1: Simulation and Mold Design

Materials Science Forum, Vol. 2018, Iss. 936, 2018-11 ,pp. : 126-135

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Tempering on Hardness of Qamp;T Steel Plate

Materials Science Forum, Vol. 2018, Iss. 941, 2019-01 ,pp. : 311-316

Trans Tech Publications

Access to resources Recommend Favorite