Research on Correlation Analysis between Process Parameters of NC Machining and Quality Data Based on Grey Relational Analysis

Publisher： Edp Sciences

E-ISSN： 2261-236x|175|issue|03053-03053

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.175, Iss.issue, 2018-07, pp. : 03053-03053

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Optimization of WEDM process during machining of Al-Al2O3 composite using Taguchi based Grey Relational Analysis

By  

MATEC Web of conference, Vol. 172, Iss. issue, 2018-06 ,pp. : 04008-04008

Edp Sciences

Access to resources Recommend Favorite

Selection of cutting parameters for the machinability of Inconel 718 using Grey Relational Analysis

By  

MATEC Web of conference, Vol. 172, Iss. issue, 2018-06 ,pp. : 04004-04004

Edp Sciences

Access to resources Recommend Favorite

Multi objective optimization for kerf and material removal rate in wire electrical discharge machining using Taguchi method combined grey relational analysis

By  

MATEC Web of conference, Vol. 204, Iss. issue, 2018-09 ,pp. : 06006-06006

Edp Sciences

Access to resources Recommend Favorite

Evaluation of Process Parameters in Machining of AA6063 Alloy

By  

Advanced Materials Research, Vol. 2018, Iss. 1148, 2018-08 ,pp. : 109-114

Trans Tech Publications

Access to resources Recommend Favorite

Research on Ultrasonic Machining Gap Control Based on Fuzzy Self-tuning PID Parameters Technology

By  

MATEC Web of conference, Vol. 208, Iss. issue, 2018-09 ,pp. : 03010-03010

Edp Sciences

Access to resources Recommend Favorite