Research on Tool Cutting Performance and Turning Simulation

Publisher： Edp Sciences

E-ISSN： 2261-236x|175|issue|03059-03059

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.175, Iss.issue, 2018-07, pp. : 03059-03059

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Numerical simulation of two tool turning process

By Khownpurk Pichnipa  

MATEC Web of conference, Vol. 192, Iss. issue, 2018-08 ,pp. : 01003-01003

Edp Sciences

Access to resources Recommend Favorite

Effects of Cutting Speed and Feed Rate on Surface Roughness in Hard Turning of AISI 4140 with Mixed Ceramic Cutting Tool

By  

Key Engineering Materials, Vol. 2018, Iss. 779, 2018-10 ,pp. : 153-158

Trans Tech Publications

Access to resources Recommend Favorite

Experimental evaluation of the influence of tool wear on the temperature in the cutting zone during the turning of metals

By  

MATEC Web of conference, Vol. 226, Iss. issue, 2018-11 ,pp. : 02011-02011

Edp Sciences

Access to resources Recommend Favorite

Prediction of cutting tool vibration and surface roughness in hard turning of AISI52100 steel

By  

MATEC Web of conference, Vol. 211, Iss. issue, 2018-10 ,pp. : 03011-03011

Edp Sciences

Access to resources Recommend Favorite

Optimization of Cutting Conditions for Turning of Ductile Materials to Achieve Favourable Chip Form

By  

Key Engineering Materials, Vol. 2018, Iss. 780, 2018-10 ,pp. : 98-104

Trans Tech Publications

Access to resources Recommend Favorite