Analysis of the Chip Geometry in Dry Machining of Aeronautical Aluminum Alloys

Author： Trujillo Vilches Francisco Javier   Sevilla Hurtado Lorenzo   Martín Fernández Francisco   Bermudo Gamboa Carolina  

Publisher： MDPI

E-ISSN： 2076-3417|7|2|132-132

ISSN： 2076-3417

Source： Applied Sciences, Vol.7, Iss.2, 2017-01, pp. : 132-132

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Failure Response of Simultaneously Pre-Stressed and Laser Irradiated Aluminum Alloys

By Jelani Mohsan   Li Zewen   Shen Zhonghua   Sardar Maryam  

Applied Sciences, Vol. 7, Iss. 5, 2017-04 ,pp. : 464-464

MDPI

Access to resources Recommend Favorite

Evaluation of a Novel Controlled Cutting Fluid Impinging Supply System When Machining Titanium Alloys

By Gariani Salah   Shyha Islam   Inam Fawad   Huo Dehong  

Applied Sciences, Vol. 7, Iss. 6, 2017-05 ,pp. : 560-560

MDPI

Access to resources Recommend Favorite

Effects of Aluminum and Strontium Content on the Microstructures and Mechanical Properties of Mg-Al-Ca-Sr Alloys

By  

Current Nanoscience, Vol. 10, Iss. 1, 2014-02 ,pp. : 108-113

Bentham Science Publishers

Access to resources Recommend Favorite

Computational Analysis and Artificial Neural Network Optimization of Dry Turning Parameters—AA2024-T351

By Saleem Waqas   Zain-ul-abdein Muhammad   Ijaz Hassan   Salmeen Bin Mahfouz Abdullah   Ahmed Anas   Asad Muhammad   Mabrouki Tarek  

Applied Sciences, Vol. 7, Iss. 6, 2017-06 ,pp. : 642-642

MDPI

Access to resources Recommend Favorite

Experimental Investigation and Finite Element Analysis of the Roll Compression Forming of Aluminum Alloy Tubes

By Rajiv S.   Sundaram K. Shanmuga  

Advanced Science Focus, Vol. 1, Iss. 2, 2013-06 ,pp. : 136-138

American Scientific Publishers

Access to resources Recommend Favorite