On the Injection Molding Processing Parameters of HDPE-TiO2 Nanocomposites

Author： Mourad Abdel-Hamid I.   Mozumder Mohammad Sayem   Mairpady Anusha   Pervez Hifsa   Kannuri Uma Maheshwara  

Publisher： MDPI

E-ISSN： 1996-1944|10|1|85-85

ISSN： 1996-1944

Source： Materials, Vol.10, Iss.1, 2017-01, pp. : 85-85

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Metal Injection Molding Process Parameters as A Function of Filling Performance of 3D Printed Polymer Mold

By  

MATEC Web of conference, Vol. 225, Iss. issue, 2018-11 ,pp. : 06004-06004

Edp Sciences

Access to resources Recommend Favorite

Fabrication of Nanosized Island-Like CdO Crystallites-Decorated TiO2 Rod Nanocomposites via a Combinational Methodology and Their Low-Concentration NO2 Gas-Sensing Behavior

By Liang Yuan-Chang   Xu Nian-Cih   Wang Chein-Chung   Wei Da-Hua  

Materials, Vol. 10, Iss. 7, 2017-07 ,pp. : 778-778

MDPI

Access to resources Recommend Favorite

Synthesis and Characterization of MoS2/TiO2 Nanocomposites for Enhanced Photocatalytic Degradation of Methylene Blue under Sunlight Irradiation

By  

Key Engineering Materials, Vol. 2018, Iss. 778, 2018-10 ,pp. : 137-143

Trans Tech Publications

Access to resources Recommend Favorite

The Effect of Injection Molding on Physical Properties of EPDM Rubber

By  

MATEC Web of conference, Vol. 210, Iss. issue, 2018-10 ,pp. : 02039-02039

Edp Sciences

Access to resources Recommend Favorite

Simple equipment for studying the injection molding process

By  

MATEC Web of conference, Vol. 178, Iss. issue, 2018-07 ,pp. : 02001-02001

Edp Sciences

Access to resources Recommend Favorite