Modeling of Processing-Induced Pore Morphology in an Additively-Manufactured Ti-6Al-4V Alloy

Author： Kabir Mohammad Rizviul   Richter Henning  

Publisher： MDPI

E-ISSN： 1996-1944|10|2|145-145

ISSN： 1996-1944

Source： Materials, Vol.10, Iss.2, 2017-02, pp. : 145-145

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Secondary Machining Characteristics of Additive Manufactured Titanium Alloy Ti-6Al-4V

By  

Key Engineering Materials, Vol. 2018, Iss. 779, 2018-10 ,pp. : 149-152

Trans Tech Publications

Access to resources Recommend Favorite

Osteoblast Cell Response on the Ti6Al4V Alloy Heat-Treated

By Chávez-Díaz Mercedes Paulina   Escudero-Rincón María Lorenza   Arce-Estrada Elsa Miriam   Cabrera-Sierra Román  

Materials, Vol. 10, Iss. 4, 2017-04 ,pp. : 445-445

MDPI

Access to resources Recommend Favorite

Biocompatibility and Corrosion Protection Behaviour of Hydroxyapatite Sol-Gel-Derived Coatings on Ti6Al4V Alloy

By El Hadad Amir A.   Peón Eduardo   García-Galván Federico R.   Barranco Violeta   Parra Juan   Jiménez-Morales Antonia   Galván Juan Carlos  

Materials, Vol. 10, Iss. 2, 2017-01 ,pp. : 94-94

MDPI

Access to resources Recommend Favorite

Effect of Multi-Pass Ultrasonic Surface Rolling on the Mechanical and Fatigue Properties of HIP Ti-6Al-4V Alloy

By Li Gang   Qu Shengguan   Xie Mingxin   Ren Zhaojun   Li Xiaoqiang  

Materials, Vol. 10, Iss. 2, 2017-02 ,pp. : 133-133

MDPI

Access to resources Recommend Favorite

Chemical polishing of samples obtained by selective laser melting from titanium alloy Ti6Al4V

By  

MATEC Web of conference, Vol. 224, Iss. issue, 2018-10 ,pp. : 01031-01031

Edp Sciences

Access to resources Recommend Favorite