Influence of Layer Thickness, Raster Angle, Deformation Temperature and Recovery Temperature on the Shape-Memory Effect of 3D-Printed Polylactic Acid Samples

Author： Wu Wenzheng   Ye Wenli   Wu Zichao   Geng Peng   Wang Yulei   Zhao Ji  

Publisher： MDPI

E-ISSN： 1996-1944|10|8|970-970

ISSN： 1996-1944

Source： Materials, Vol.10, Iss.8, 2017-08, pp. : 970-970

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Fabrication and Characterization of 3D-Printed Highly-Porous 3D LiFePO4 Electrodes by Low Temperature Direct Writing Process

By Liu Changyong   Cheng Xingxing   Li Bohan   Chen Zhangwei   Mi Shengli   Lao Changshi  

Materials, Vol. 10, Iss. 8, 2017-08 ,pp. : 934-934

MDPI

Access to resources Recommend Favorite

Mechanical Properties of 3D-Printed Wood-Plastic Composites

By  

Key Engineering Materials, Vol. 2018, Iss. 777, 2018-10 ,pp. : 499-507

Trans Tech Publications

Access to resources Recommend Favorite

A low cost 3D-printed robot joint torque sensor

By  

MATEC Web of conference, Vol. 197, Iss. issue, 2018-09 ,pp. : 11006-11006

Edp Sciences

Access to resources Recommend Favorite

Optically Clear and Resilient Free-Form μ-Optics 3D-Printed via Ultrafast Laser Lithography

By Jonušauskas Linas   Gailevičius Darius   Mikoliūnaitė Lina   Sakalauskas Danas   Šakirzanovas Simas   Juodkazis Saulius   Malinauskas Mangirdas  

Materials, Vol. 10, Iss. 1, 2017-01 ,pp. : 12-12

MDPI

Access to resources Recommend Favorite

Failure Observation of 3D-Printed Thrust Bearing Specimens at Cross Section Observations in Dry Conditions

By  

Key Engineering Materials, Vol. 2018, Iss. 777, 2018-10 ,pp. : 446-450

Trans Tech Publications

Access to resources Recommend Favorite