Non Treatment, T4 and T6 on Tensile Strength of Al-5.9Cu-1.9Mg Alloy Investigated by Variation of Casting Temperature

E-ISSN： 1662-9752|2018|929|56-62

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2018, Iss.929, 2018-09, pp. : 56-62

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Microstructural Comparison of an Al-8.0Zn-1.8Mg-2.0Cu Alloy with Typical T6 and T76 Tempers

Materials Science Forum, Vol. 2018, Iss. 941, 2019-01 ,pp. : 753-758

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Solution Treatment Temperature on Microstructure and Mechanical Properties of Al-5.1Zn-2Mg-0.1Ti (wt. %) Produced by Squeeze Casting

Materials Science Forum, Vol. 2018, Iss. 939, 2018-12 ,pp. : 38-45

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Hot-Rolled Process and Heat Treatment on Microstructure and Mechanical Properties of Ti-6Al-4V ELI Alloy

Materials Science Forum, Vol. 2019, Iss. 944, 2019-02 ,pp. : 73-78

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Sn Content on Heat Resistance of Mg-3%Al-1%Si Alloy for Casting

Materials Science Forum, Vol. 2018, Iss. 941, 2019-01 ,pp. : 1071-1076

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Cold Rolling and Annealing Temperature on the Characteristics of Cu-28Zn-1.1Bi Alloy Produced by Gravity Casting

Materials Science Forum, Vol. 2018, Iss. 939, 2018-12 ,pp. : 73-80

Trans Tech Publications

Access to resources Recommend Favorite