

Publisher: Edp Sciences
E-ISSN: 2261-236x|182|issue|01020-01020
ISSN: 2261-236x
Source: MATEC Web of conference, Vol.182, Iss.issue, 2018-07, pp. : 01020-01020
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
The article presents possibilities of extending the scope of ABS / ESP systems control as part of periodic vehicle technical inspection. It was proposed to check the functioning of the ABS / ESP system based on the evaluation of its effects in the form of dynamic changes of braking forces measured on the roller diagnostic stand. The tested system is started by a diagnostic tester through the OBD socket in the car during the implementation of active tests. The effect of the system is checked on the basis of the analysis of the course of braking forces. This allows to detect those mechatronic system failures that are not detected by on-board diagnostic systems. The algorithms for control of ABS and ESP modulators using diagnostic testers are presented.
Related content


Vibration measures in the diagnostics of technical systems
MATEC Web of conference, Vol. 182, Iss. issue, 2018-07 ,pp. :


Projection of the hydraulic pressure drive with application of partial synthesis
MATEC Web of conference, Vol. 226, Iss. issue, 2018-11 ,pp. :




Computer models of hydraulic systems of district heating
MATEC Web of conference, Vol. 193, Iss. issue, 2018-08 ,pp. :


Synthesis of High-Precision Hydraulic Control Systems of an Excavator
MATEC Web of conference, Vol. 196, Iss. issue, 2018-09 ,pp. :