Publisher： Edp Sciences
E-ISSN： 2261-236x|183|issue|03007-03007
ISSN： 2261-236x
Source： MATEC Web of conference, Vol.183, Iss.issue, 2018-07, pp. : 03007-03007
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
The results of roller burnishing parameters analysis with selfacting feed are presented in this paper. Method of parameter process design based on the quality losses G. Taguchi function was applied. The following controlled parameters were assumed: Ra - roughness parameter before roller burnishing process, w - interference between a roller and a burnished sample. k - multiplication factor of each sample point deformation, V - burnishing velocity. The following factors were assumed as process disturbances: treated material hardness and lubrication of burnished surface. Basing on experimental results it was found that strongest influence (in tested range of parameters variations) on roller burnished surface roughness has initial surface roughness and burnishing velocity. These factors also showed have the smallest resistance to process disturbances.
Related content
Access to resources
Recommend
MATEC Web of conference, Vol. 178, Iss. issue, 2018-07 ,pp. :
Study on design of temperature - dependence of sublimation transfer roller
MATEC Web of conference, Vol. 185, Iss. issue, 2018-07 ,pp. :
MATEC Web of conference, Vol. 224, Iss. issue, 2018-10 ,pp. :