Stress-strain state of a three-layer rod. Comparison of the results of analytical and numerical calculations with the experiment

Publisher： Edp Sciences

E-ISSN： 2261-236x|196|issue|01057-01057

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.196, Iss.issue, 2018-09, pp. : 01057-01057

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Analytical analysis of the stress-strain state of the system “mechanized equipment complex - support – rock mass” in the bottomhole area of the shaft

By  

MATEC Web of conference, Vol. 193, Iss. issue, 2018-08 ,pp. : 02026-02026

Edp Sciences

Access to resources Recommend Favorite

Analysis the effects of lightweight concrete in the middle layer of multi-layered reinforced concrete structures on the stress-strain state using the finite element method

By  

MATEC Web of conference, Vol. 196, Iss. issue, 2018-09 ,pp. : 02022-02022

Edp Sciences

Access to resources Recommend Favorite

Estimation of the stress-strain state of ultra-low pressure tires

By  

MATEC Web of conference, Vol. 182, Iss. issue, 2018-07 ,pp. : 01016-01016

Edp Sciences

Access to resources Recommend Favorite

Stress-strain state analysis of structures based on the monitoring data

By  

MATEC Web of conference, Vol. 196, Iss. issue, 2018-09 ,pp. : 01023-01023

Edp Sciences

Access to resources Recommend Favorite

Influence of Inhomogeneity of the Foundation on the Stress-strain State of the Design Located on it

By  

MATEC Web of conference, Vol. 196, Iss. issue, 2018-09 ,pp. : 01009-01009

Edp Sciences

Access to resources Recommend Favorite