The Investigation of the Influence of Friction and Roll Calibration on the Pipe Formation during Plug Rolling

Publisher： Trans Tech Publications

E-ISSN： 1662-9779|2018|284|552-556

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2018, Iss.284, 2018-11, pp. : 552-556

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Investigation of Pipe Ends Formation under Reduction Mill Rolling

By  

Solid State Phenomena, Vol. 2018, Iss. 284, 2018-11 ,pp. : 557-562

Trans Tech Publications

Access to resources Recommend Favorite

A Study of the Influence of the Manufacturing Process Parameters on the Distribution of Residual Stresses in Pipe Walls during Sink Drawing

By  

Solid State Phenomena, Vol. 2018, Iss. 284, 2018-11 ,pp. : 542-546

Trans Tech Publications

Access to resources Recommend Favorite

Strain State during Rolling of Aluminum Samples

By  

Solid State Phenomena, Vol. 2018, Iss. 284, 2018-11 ,pp. : 436-440

Trans Tech Publications

Access to resources Recommend Favorite

Influence of the State of the Contact Surfaces on the Formation of the Joint of Steel and Brass during Cold Cladding

By  

Solid State Phenomena, Vol. 2018, Iss. 284, 2018-11 ,pp. : 319-325

Trans Tech Publications

Access to resources Recommend Favorite

Method for Determining the Optimum Counter-Flexing Force of Working Rolls during Sheet Rolling

By  

Solid State Phenomena, Vol. 2018, Iss. 284, 2018-11 ,pp. : 416-424

Trans Tech Publications

Access to resources Recommend Favorite