Development of Composite Materials for 3d Printing on the Basis of Polyphenylenesulfone

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2018|935|15-20

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2018, Iss.935, 2018-11, pp. : 15-20

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Preparation and Performance of the Cement-Based Concrete 3D Printing Materials

By  

Materials Science Forum, Vol. 2018, Iss. 932, 2018-10 ,pp. : 131-135

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of the Influence of Fillers of Various Nature on the Properties of Polyether Sulfone and Determination of the Possibility of Using Composites on their Basis in 3D-Printing

By  

Materials Science Forum, Vol. 2018, Iss. 935, 2018-11 ,pp. : 11-14

Trans Tech Publications

Access to resources Recommend Favorite

Patterned Magnetorheological Elastomer Developed by 3D Printing

By  

Materials Science Forum, Vol. 2018, Iss. 939, 2018-12 ,pp. : 147-152

Trans Tech Publications

Access to resources Recommend Favorite

Fiber Concrete on the Basis of Composite Binder and Technogenic Raw Materials

By  

Materials Science Forum, Vol. 2018, Iss. 931, 2018-10 ,pp. : 603-607

Trans Tech Publications

Access to resources Recommend Favorite

Mechanical Properties of Samples of Polyphenylene Sulfone Obtained by the 3D-Printing Method

By  

Materials Science Forum, Vol. 2018, Iss. 935, 2018-11 ,pp. : 21-26

Trans Tech Publications

Access to resources Recommend Favorite