Theoretical investigation of the effect of the taper angle of the deforming roller on the limiting degrees of deformation in the process of flow forming

Publisher： Edp Sciences

E-ISSN： 2261-236x|224|issue|01040-01040

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.224, Iss.issue, 2018-10, pp. : 01040-01040

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Numerical study on the effect of the die compression angle on extrusion forming of plastic pipe

By  

MATEC Web of conference, Vol. 175, Iss. issue, 2018-07 ,pp. : 02009-02009

Edp Sciences

Access to resources Recommend Favorite

Investigation of Flow over the Airfoil NACA 0010-35 with Various Angle of Attack

By Xiao Shiming  

MATEC Web of conference, Vol. 179, Iss. issue, 2018-07 ,pp. : 03020-03020

Edp Sciences

Access to resources Recommend Favorite

Investigation of the effect of the angle between drive shafts on vibration responses of main reducer

By Liu Xiaogang  

MATEC Web of conference, Vol. 189, Iss. issue, 2018-08 ,pp. : 06009-06009

Edp Sciences

Access to resources Recommend Favorite

The Effect of Lubrication on the Vibration of Roller Bearings

By  

MATEC Web of conference, Vol. 217, Iss. issue, 2018-10 ,pp. : 01004-01004

Edp Sciences

Access to resources Recommend Favorite

Investigation of a partial, inductive short-time heat treatment of thin metal sheets integrated into the forming process

By  

MATEC Web of conference, Vol. 190, Iss. issue, 2018-09 ,pp. : 12008-12008

Edp Sciences

Access to resources Recommend Favorite