Bases of variational method for calculating of metal-cutting systems accuracy

Publisher： Edp Sciences

E-ISSN： 2261-236x|224|issue|01038-01038

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.224, Iss.issue, 2018-10, pp. : 01038-01038

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The influence of hydrojet surface processing on the adhesive strength of wear-resistant coatings deposited on a metal-cutting tool of oxynitride ceramics

By  

MATEC Web of conference, Vol. 224, Iss. issue, 2018-10 ,pp. : 01066-01066

Edp Sciences

Access to resources Recommend Favorite

Development of an algorithm for calculating the number of regrindings for a shaver with the continuous spiral cutting edge

By  

MATEC Web of conference, Vol. 224, Iss. issue, 2018-10 ,pp. : 01100-01100

Edp Sciences

Access to resources Recommend Favorite

The method of dynamic operating modes investigation in electrohydraulic drive systems with improved accuracy of positioning executive elements

By  

MATEC Web of conference, Vol. 226, Iss. issue, 2018-11 ,pp. : 04024-04024

Edp Sciences

Access to resources Recommend Favorite

Method for calculating the power of a rotor-screw machines

By  

MATEC Web of conference, Vol. 226, Iss. issue, 2018-11 ,pp. : 01007-01007

Edp Sciences

Access to resources Recommend Favorite

Method for calculating the maximum number of railway cars in a cut

By  

MATEC Web of conference, Vol. 216, Iss. issue, 2018-10 ,pp. : 02011-02011

Edp Sciences

Access to resources Recommend Favorite