Computation method of geometry die of stretch forming press

E-ISSN： 2261-236x|224|issue|04014-04014

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.224, Iss.issue, 2018-10, pp. : 04014-04014

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Hot stretch forming of titanium sheet by resistance heating

MATEC Web of conference, Vol. 190, Iss. issue, 2018-09 ,pp. : 07003-07003

Edp Sciences

Access to resources Recommend Favorite

Numerical study on the effect of the die compression angle on extrusion forming of plastic pipe

MATEC Web of conference, Vol. 175, Iss. issue, 2018-07 ,pp. : 02009-02009

Edp Sciences

Access to resources Recommend Favorite

Investigation of microstructure and hardness of a rib geometry produced by metal forming and wire-arc additive manufacturing

MATEC Web of conference, Vol. 190, Iss. issue, 2018-09 ,pp. : 02005-02005

Edp Sciences

Access to resources Recommend Favorite

Forming parameters optimizations with drawing force and die stress in wire rod drawing using rotating die under Coulomb friction

By Tiong Ing-Kiat

MATEC Web of conference, Vol. 185, Iss. issue, 2018-07 ,pp. : 00025-00025

Edp Sciences

Access to resources Recommend Favorite

In-situ measurement technologies for flow behaviour and contact status of fibre-reinforced thermoplastics during forming with a six degree of freedom press

MATEC Web of conference, Vol. 190, Iss. issue, 2018-09 ,pp. : 07004-07004

Edp Sciences

Access to resources Recommend Favorite