Management of space orientation of the end effector of generation of geometry system fiveaxis manufacturing machinery for additive generation of geometry

Publisher： Edp Sciences

E-ISSN： 2261-236x|226|issue|01004-01004

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.226, Iss.issue, 2018-11, pp. : 01004-01004

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Evaluation of the Thermal Processes and Simulation Methods for Additive Manufacturing Based on the Geometry Voxel Representation

By  

Key Engineering Materials, Vol. 2018, Iss. 771, 2018-08 ,pp. : 91-96

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of microstructure and hardness of a rib geometry produced by metal forming and wire-arc additive manufacturing

By  

MATEC Web of conference, Vol. 190, Iss. issue, 2018-09 ,pp. : 02005-02005

Edp Sciences

Access to resources Recommend Favorite

Challenges in Additive Manufacturing of Space Parts: Powder Feedstock Cross-Contamination and Its Impact on End Products

By Brandão Ana D.   Gerard Romain   Gumpinger Johannes   Beretta Stefano   Makaya Advenit   Pambaguian Laurent   Ghidini Tommaso  

Materials, Vol. 10, Iss. 5, 2017-05 ,pp. : 522-522

MDPI

Access to resources Recommend Favorite

The key management method for the system of end-to-end symmetric database encryption

By  

MATEC Web of conference, Vol. 226, Iss. issue, 2018-11 ,pp. : 05002-05002

Edp Sciences

Access to resources Recommend Favorite

Knowledge management in multi-generation workforce: investigation on critical success factor and strategy

By  

MATEC Web of conference, Vol. 218, Iss. issue, 2018-10 ,pp. : 04010-04010

Edp Sciences

Access to resources Recommend Favorite