Effect of Type of Fiber on Inter-Layer Bond and Flexural Strengths of Extrusion-Based 3D Printed Geopolymer

E-ISSN： 1662-9752|2018|939|155-162

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2018, Iss.939, 2018-12, pp. : 155-162

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Binder Saturation Level on Compressive Strength and Dimensional Accuracy of Powder-Based 3D Printed Geopolymer

Materials Science Forum, Vol. 2018, Iss. 939, 2018-12 ,pp. : 177-183

Trans Tech Publications

Access to resources Recommend Favorite

30-kW All-SiC Inverter with 3D-Printed Air-Cooled Heatsinks for Plug-In and Full Electric Vehicle Applications

Materials Science Forum, Vol. 2018, Iss. 924, 2018-07 ,pp. : 845-848

Trans Tech Publications

Access to resources Recommend Favorite

The Preparation and Performance of the Cement-Based Concrete 3D Printing Materials

Materials Science Forum, Vol. 2018, Iss. 932, 2018-10 ,pp. : 131-135

Trans Tech Publications

Access to resources Recommend Favorite

Synthesis and Characterization of Red Mud and Sawdust Based Geopolymer Composites as Potential Construction Material

Materials Science Forum, Vol. 2018, Iss. 923, 2018-06 ,pp. : 130-134

Trans Tech Publications

Access to resources Recommend Favorite

3D FEM Simulation of the Effect of Cooling Rate on SDAS and Macrosegregation of a High Strength Steel

Materials Science Forum, Vol. 2018, Iss. 941, 2019-01 ,pp. : 2360-2364

Trans Tech Publications

Access to resources Recommend Favorite