Effect of Lubrication Conditions on the Forming Limit of Deep Drawing of 6061 Aluminum Alloy Sheet

E-ISSN： 1662-9752|2019|944|85-91

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2019, Iss.944, 2019-02, pp. : 85-91

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Forming Behaviour at Elevated Temperature of a Laser Heat-Treated AZ31 Magnesium Alloy Sheet

Materials Science Forum, Vol. 2018, Iss. 941, 2019-01 ,pp. : 1270-1275

Trans Tech Publications

Access to resources Recommend Favorite

Mechanical Interlocking of an Aluminum Alloy and SS400 Structural Steel through Friction-Stir Spot Forming (FSSF)

Materials Science Forum, Vol. 2018, Iss. 926, 2018-08 ,pp. : 17-22

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and Mechanical Properties of Aluminum Alloy/High Strength Steel Double Beam Laser Deep Penetration Welded Joint

Materials Science Forum, Vol. 2019, Iss. 944, 2019-02 ,pp. : 448-457

Trans Tech Publications

Access to resources Recommend Favorite

Cryogenic Sheet Metal Forming - An Overview

Materials Science Forum, Vol. 2018, Iss. 941, 2019-01 ,pp. : 1397-1403

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Deep Rolling Process Parameters on Surface Residual Stress of AA7075-T651 Aluminum Alloy Friction Stir Welded Joint

Materials Science Forum, Vol. 2018, Iss. 939, 2018-12 ,pp. : 23-30

Trans Tech Publications

Access to resources Recommend Favorite