Microstructure of Al-17wt.%Si Alloy after Overheating and CuP Master Alloy Modification

Publisher： Trans Tech Publications

E-ISSN： 1662-9779|2015|229|11-16

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2015, Iss.229, 2015-05, pp. : 11-7

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Modification with CuP Master Alloy and Rapid Crystallization on the Tribological Properties of AlSi17Cu5Mg Alloy

By  

Solid State Phenomena, Vol. 2016, Iss. 246, 2016-03 ,pp. : 153-156

Trans Tech Publications

Access to resources Recommend Favorite

Morphological Evolution of Al-2wt%Si-2.5wt%Cu Alloy Produced by EMS and EMS Enhanced by ECAP

By  

Solid State Phenomena, Vol. 2014, Iss. 217, 2015-01 ,pp. : 105-7

Trans Tech Publications

Access to resources Recommend Favorite

Effect of a short solution treatment time on microstructure and mechanical properties of modified Al-7wt.%Si-0.3wt.%Mg alloy

By Zhang D.L.   Zheng L.H.   StJohn D.H.  

Journal of Light Metals, Vol. 2, Iss. 1, 2002-02 ,pp. : 27-36

Elsevier

Access to resources Recommend Favorite

Correlation between Thermal Parameters, Primary Dendrite Arm Spacing and Microhardness on a Directionally Solidified Ternary Al-6wt%Cu-8wt%Si Alloy

By  

Defect and Diffusion Forum, Vol. 2015, Iss. 365, 2015-08 ,pp. : 136-141

Trans Tech Publications

Access to resources Recommend Favorite

Comparison of Morphological Evolution of Al-7wt%Si-2.5wt%Cu Alloy Produced by Direct Chill Casting/Electromagnetic Stirring and ECAP

By  

Solid State Phenomena, Vol. 2016, Iss. 256, 2016-10 ,pp. : 17-24

Trans Tech Publications

Access to resources Recommend Favorite