Influence of Technological Options on the Material Reliability of AlSi17Cu5 Cast Alloy

E-ISSN： 1662-9779|2015|229|17-24

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2015, Iss.229, 2015-05, pp. : 17-9

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Analysis of Surface Coarseness for Friction Node of Alloy AlSi17Cu5 and Cast-Iron EN-GJL-350

Solid State Phenomena, Vol. 2016, Iss. 246, 2016-03 ,pp. : 149-152

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Modification with CuP Master Alloy and Rapid Crystallization on the Tribological Properties of AlSi17Cu5Mg Alloy

Solid State Phenomena, Vol. 2016, Iss. 246, 2016-03 ,pp. : 153-156

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Annealing of Al-5Ti-1B Master Alloy on Hot Tearing of Cast Al-7Si-3Cu Alloy

Key Engineering Materials, Vol. 2017, Iss. 737, 2017-07 ,pp. : 27-31

Trans Tech Publications

Access to resources Recommend Favorite

Spheroidization of the Al-Si eutectic in a cast aluminum alloy

By Páramo Víctor Colás Rafael Velasco Eulogio Valtierra Salvador

Journal of Materials Engineering and Performance, Vol. 9, Iss. 6, 2000-12 ,pp. : 616-622

Springer Publishing Company

Access to resources Recommend Favorite

The debonding and fracture of Si particles during the fatigue of a cast Al-Si alloy

By Gall Ken Yang Nancy Horstemeyer Mark McDowell David Fan Jinghong

Metallurgical and Materials Transactions A, Vol. 30, Iss. 12, 1999-12 ,pp. : 3079-3088

Springer Publishing Company

Access to resources Recommend Favorite